欧美午夜免费影院,中文字幕亚洲一区二区av在线,日韩伦理精品

Model No: AMP-10
Factory Location: Taiwan
Sample Request: No
Target Markets: Worldwide

Detail Information

Description :

1. Amp-10 is built for the purpose to transmit the GPS satellite signal from outdoor to indoor, and re-radiating the receptions for multi-users to operate GPS Receivers inside buildings or vehicles.
2. For L1 band GPS signal, meets most of the GPS Receivers on the market.
3. Amp-10 is a re-radiating equipment. It can receive the outdoor GPS satellite signal and conduct to indoor place for radiating again. When a GPS Satellite is revolving around the earth it will transmit continuously satellite signal to the earth, but the strength of satellite signal will weaken to only around -125dBm when it arrived to the earth ground. Such weak signal can't penetrate into buildings or vehicles; besides, its reflection or scattering signal can be detected only in around windows area.
4. Amp-10 is built for the purpose to transmit the GPS satellite signal from outdoor to indoor, and re-radiating the receptions for multi-users to operate GPS Receivers inside buildings or vehicles. Therefore, users can work the GPSequipments indoor same as using it outdoor.

Specification :

1. Power required: 10~26VDC, less than 25mA, @12VDC input (active antenna not included). 2. Gain: ~24dB. 3. Frequency: L1 band, 1575.42 +/- 10MHz. 4. LED indication: red (for power input). 5. Operation temperature: -40 ? ~ +80 ?. 6. Operation humidity: 5% ~ 95%. 7. Dimension: 107 x 67 x 20 mm (main body). 8. Weight: 110 g. 9. Radiation antenna: the length of dipole are 6 cm the length of RG-174U cable are 200 cm. 10. Radiation antenna range: one meter around. 11. MCX connector: providing 5V, 25mA power for the external active antenna. 12. External active antenna impedance: 50 ohm. 13. External antenna gain: average 26dB need, for 2-5 meter cable, but it may depends on the length of cable.