Description :

Yomura is capable of manufacturing water protection parts and running the tests up to IP68. Our Water protection injection products are widely for Camera, Light, Medical, etc.

Specification :

The IP rating found in electronic data sheets or specifications was designed to give the consumer reliable standards for rating the suitability of enclosures for conditions such as rain and dust.  Technically, IP (not to be confused with IP address, which stands for internet protocol address),? the term stands for Ingress Protection rating? according to ISO.

The rating consists of numeric values.  The first digit is a number (0-6) which indicates the size of the particles for which the enclosure is rated.  A rating of 5? means it is protected against dust though there can be a nominal amount of dust that might intrude the enclosure, but a 6? means it is an enclosure that eliminates all dust. All electronic products should always come with a rating of 6,? dust-free.

The second digit of the rating is a number (0-8) which describes the potential for intrusion by water.  A number of 4? means that splashing water from any side? will not have a harmful effect on the protected mechanical or electrical component encased.  An 8? means that the enclosure can be continuously immersed in water over one meter in depth.  A 7? means it can protect internal devices in an immersed condition up to one meter in depth, but it is approved for this rating by testing for only thirty minutes.

An IP rating of IP 67? means that it is an enclosure that can be considered as dust-free? and it can withstand submersion in water for no longer than thirty minutes and not over one meter in depth.

When applying the IP rating to electronic products, consumers should be aware that the threshold for indoor versus outdoor applications (when not protected by an overhang) should be at minimum an IP 64.  This rating accomplishes protection of the security camera circuitry against all dust and splashing water from any direction.

• 
  Plastic Injection Moldings
• 
  Light Pipe Product Design & Co-Design Engineering Services
• 
  Overmolding And Insert Moldings
• 
  Overmolding And Insert Moldings
• 
  Two Shot Injection Moldings
• 
  In Mold Decoration (IMD)
• 
  OVER INJECTION MOLD
• 
  Liquid Injection Molding

More