Description :

1. Product- Single head sander with thickness control.
2. CORE SANDER(FOR CALIBRATION)
Model:WBSC-1H
Max. Workable Size : 1320W
Required Power : 72 Kw

WHY DO YOU NEED THIS MACHINE
* Bad quality from lathe produces uneven thickness of core veneer due to the outorn plywood.Core sander can increase the re-usable ratio of veneer.
* Raising recovery from small diameter log and bad quality log.
* Cost too much time in repair work of thin plywood such as overlap.
* Save the usage of glue efficiently.

Special Construction
* New design in sanding roller. Traditional sanding roller is perpendicular to the plywood feeding direction. It’s difficult to remove overlap and uneven thickness core problem. And often damage the core which is in bad adhesively. So we design ANGULAR SANDING ROLLER , it has 8 degree with plywood feeding direction .It will easy to sanding out overlap problem .And can save about 20% power.
* Vacuum table and feeding conveyor , we make a vacuum table under sanding roller and we pierce hole in feeding conveyor .When plywood goes into sanding roller will hold by air-suction ,so plywood will flat and steady .It is especially for the thin plywood .
* Special steel sanding roller with 75 HP motor , big steel sanding roller(diameter 310mm) and big power provide the best calibration function for plywood thickness control , especially for thick plywood .And good heat emission for 24 hour non-stop running.

Safety Construction :
* The First feeding roller with one way bearing to prevent panel rebound when feeding.
* Safety protection design when machine in abnormal operation will auto-stop . Such as plywood too thick , sanding Amps over , sanding paper in abnormal condition….
* The patented fork type pressure shoe and grooved pinch roller fully eliminate the bothersome problems of panel inserting , jamming warping during panel feeding.

Specification :

• 
  Cold Press
• 
  Automatic Stacker
• 
  Double Face Glue Spreader
• 
  Bottom Surface Sander
• 
  Plywood Double Sizer