Description :

The cloisonné enamel is made primarily of boric acid, saltpeter, and alkaline. After the mixture has cooled and become a solid, it is ground into a fine powder and mixed with water. It is in this form that it is applied to the pin.
After the cloisonné enamel is applied, the pin is fired at over 1000 degrees C. It is then sanded, polished, then welded to its backing. After the copper filigree is shined, it is put through a final, electroplating process.
It is only through this complicated process that the finished product appears before your eyes. If certain details are lost, screen-printing can compensate for the imperfections and achieve the desired result.

Specification :

1. Die struck lapel pin in soft enamel filled. 2. With or without epoxy coating. 3. 1/2 inch up to 3 inches or larger. 4. Custom design welcomed. 5. Butterfly clutch, military clutch or tie tack attached. 6. Minimum order is negotiable. 7. Delivery: Depends on the quantity. 8. All the colors from the Pantone Color Formula Guide are available. 9. Product photos in this ad are for reference only.

• 
  Die Struck And Cloisonne Enamel Pins
• 
  Key Rings (Die Struck And Photo - Etching Process)
• 
  Printing Pins
• 
  Police Officer Badges
• 
  Souvenir Sets
• 
  Photo Etching Pins
• 
  Leather Keyrings With Emblems
• 
  Challenge And Award Coin Badges

More