Description :

Solenoid control valve is a kind of isolation valve, which can substitute traditional gate valves, ball valve and butterfly valves. The gate functioning is easily controlled by electrical power. The valve can be installed in fire control facility, water supply, or
distant location where it's difficult to control the gate opening. The controller is directly fixed and can be easily installed on piping site. nterchangeable between manual and solenoid control.

Specification :

1. Working voltage AC110V, 220V 50 / 60Hz. 2. Electrifying time range 1 year continuously for 10,000 hours. 3. Allowable voltage range: ±10%. 4. Working temperature: -5~80. 5. Durability- 500,000 cycles. 6. Working pressure range: 0.3kgf/cm2 ~ 10kgf/cm2. 7. Generally NC (open when switch on)type, special order is needed for NO(close when switch off) type.

Features :

1. The working pressure should be greater than 0.3 kgf/cm2, please check the pressure before installation.
2. Please remove impurities or metal dusts inside the pipe thoroughly. If possible, please add filter to prevent pipe blocking.
3. Avoid upside-down installation under insufficient flow.
(Valve's inlet should face up when it is installed)

• 
  Direct Activated Pressure Reducing Valves
• 
  Back Pressure Valves
• 
  Direct Activated Pressure Reducing Valves
• 
  Pressure Relief Valves
• 
  Float Valves
• 
  Angle Valve Water Hammer Arresters
• 
  Ball Control Valves